The Green Apron

A friend said if I make the aprons, she will sell them.  So I did. 

You will need:

1 yard light green fabric

1/2 yard dark green fabric

Ribbon (yardage varies, but I bought a 3 yard roll and used some on another project)

Insul-brite

Batting

Thread

Apron:

Cut the apron panel 20 X 30 inches.  Fold 1/4 inch under on both 20 inch sides and one 30 inch side.  Iron down, then fold again 1/4 inch.  Sew down hem on all three sides.  

Fold and iron the TOP raw edge down 1/4 inch towards the FRONT.  

Cut a length of ribbon.  On this apron, I used it only for the apron front, so I cut 31 inches of ribbon. Pin the ribbon over the folded down raw edge, matching folded edge. Fold a half inch on each end, under.   

**Cut two strips of fabric 3 inches by 20 inches.  With right sides together and raw edges even, sew one end and then the entire open side.  Turn right side out.  Tuck the raw edge of the ties under the folded edge of ribbon. Sew the entire ribbon down, sewing over the ties on each end. 

Pockets - Cut two 7 inch squares from contrasting fabric.  Fold down 1/4 inch on 3 sides and iron down.  On the 4th side, fold down 1 inch.  Pin both squares to the apron front, and center.  Sew all the way around the two sides and bottom. 

** You can cut the ribbon 60 inches and center it on the apron front.  Sew it down to the apron, and you won't need to make the ties. 

Pot-Holders:

Cut two 7 inch squares from the light fabric and two 7 inch squares from the dark fabric.  Cut one 7 inch square from the Insul-Brite and one 7 inch square from the batting. 

Lay Insul-Brite down first, then batting.  Lay light fabric right side UP, and dark fabric, right side DOWN.  Cut two 5 inch ribbon  pieces and if it is wide, fold over wrong sides together and sew down side.  Pin the ribbon in one corner between the two layers of fabric on each pot-holder, with the loop towards the inside of the square.  Sew all the way around, leaving a small opening for turning.  Turn right side out, poke corners out with poking tool, and then top stitch all the way around the edge, closing the hole.  Do a simple quilting design on top - I just did from corner to corner and the made a cross from top to bottom and side to side.   

Coasters:

Cut four 5 inch squares of batting. 

Cut three 5 inch squares of light fabric

Cut two five inch squares of dark fabric

Iron 2 each of light and dark fabrics in half, with right sides OUT. 

Lay the batting down.  Lay the un-ironed square in top, with right side UP.  Lay the two light ironed pieces on top, next to each other, with folded edges towards the center.  Lay one dark ironed piece on top crosswise, lifting one end of a light piece to tuck it under.  Do the same, but opposite, with the other dark square. They should look "basket-woven."  Pin through all layers in the center.  Sew all the way around on the edge.  Do not worry if the fabric slips a little - just keep the centers together.  Pull the pins out, trim the corners (don't cut the seams!), then pull the fabric through the CENTER hole, to turn it right side out.  Poke the corners lightly through the hole to square up.  Iron lightly to make it lay down.   

These make great little hostess gifts, or for your favorite cook.  You can use any fabric - make some for the holidays!